Compuprint 6314 CDL Manual de usuario descargar pdf (Pagina 16)

CDL – Programmer Manual

This command, since it is a label definition command, is a local command that is effective only on

the current label: the default value is the one set by the HEAD TEMPER. SELECTION parameter

mentioned above.

m – Metric system

After this command, the co-ordinates are read as tenths of a millimetre instead of hundredths of an

inch. To return to hundredths of an inch, you need to enter a subsequent command n.

n – Imperial system

After an m command, with a current n command the printer returns to the imperial system in which

all numerical parameters are read in hundredths of an inch (this is the default setting).

Pa – Printing speed

You can select the label printing speed with this command.

Since it is a label definition command, it is local.

a may be set at the following speeds:

a Speed (ips

)

A 2

B 2

C 2

D 2,5

E 3

F 3,5

H 4,5

I 5

J 5,5

L 6,5

M 7

N 7,5

e.g. with command PG the printer prints the current label at a speed of 4 ips.

pa – Backfeed speed

With this command you can select the label backfeed speed (see command STX fnnn).

Since it is a label definition command, it is local.

a may be set at the following speeds:

Inches per second.

Default and max. speed.

Default speed for models with expander card.

Max. speed for models with expander card.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 52 53

Sin comentarios

Compuprint 6314 CDL Manual de usuario Pagina 16