Compuprint SP40 Manual de usuario descargar pdf (Pagina 28)

Printing the Test Page

The Self Test page is useful to test, if the printer has been correctly installed, and allows to see

the current parameter settings.

1. With the printer in the Setup Mode, insert a single sheet in A4 or Letter format.

2. The printer loads the sheet and stops.

3. Press the ON LINE key again.

The printer prints the Self-Test page. Check that the printout is correct. The following printout

example shows the Printer Setup default values.

Once the self-test is finished, the printer remains in Setup Mode.

SELF TEST

SP40 : Code Version Vx.x xxxxxxxx CharGen:xxxxxxxx ver. x.xx

CONFIGURATION SETUP

PROGRAM on interface AUTOFEED SIGNAL disabled

ERROR BUZZER enable SLCT-IN SIGNAL disabled

JOB BUZZER no beep IGNORE PE enabled

COPIES yes BUFFER CONTROL DTR+SRTS

LOW NOISE no ROBUST XON enabled

EDGE DETECTION Normal WORD LENGTH 8 bit

SAFE BOTTOM EDGE yes BAUD RATE 9600 bps

GET EDGE QUOTE 1/4” PARITY BIT none

PASSBOOK TYPE sw control STOP BIT 1

fixed thick

INTERFACE TYPE automatic

IBM FINANCIAL no

INPUT BUFFER 8 Kb PRINT HEAD LIFE xxxxx chars

RIBBON LIFE xxxxx chars

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Sin comentarios

Compuprint SP40 Manual de usuario Pagina 28