Compuprint 914 Manual de usuario descargar pdf (Pagina 116)

{n1} and{n2}

The {n1} and{n2} parameters specify the number of bytes in the escape

sequence normally,

n1 1,3 or 4

n2 Always 0

{init}

The {init} parameter specifies to which condition the printer should initialize,

normally {init} = 0,1,4, 5, 254 and 255.The first four values definitions affect the

mode settings (i.e. quality, pitch or print mode) that can be selected via operator

panel if no parameters are specified, however if the 0,1,or 256 values and the

parameter(s) are specified, these ones overwrite the user function selection.

init Description

0 Printer initialized to user default setting. Download font is not cleared

1 Printer initialized to user default setting. Download font is cleared

4 Printer initialized to factory default setting.Download font is not cleared

FE Printer performs as value 1.Initialization results are saved and become

the user default setting

FF Printer performs as value 1.Initialization results are saved and become

the user default setting

{id}

The {id} parameter specifies the printer for which the following parameter

bytes are intended. If the ID does not address your printer , the mode bytes that

follow are ignored.

{parm1}

The {parm1} parameter specifies which printer function is enable (on) or

disable (off). These are the value definitions

Bit OFF ON

7 Discard byte Process this byte Ignore this byte

6 Reserved

5 Alarm enable Enable Disable

4 Auto CR No CR on vertical movement CR on vertical movement

Appendix A

A.32

A78401745-001

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 145 146

Sin comentarios

Compuprint 914 Manual de usuario Pagina 116